ANSYS based Modal Analysis of a Fixed Beam of Uniform Cross Section with a Concentrated Mass at Mid Span

Authors

  • Abhishek Bhandari Department of Mechanical Engineering, Pulchowk Engineering Campus, Institute of Engineering, Tribhuvan University, Lalitpur, Nepal
  • Akin Chhetri Department of Mechanical Engineering, Pulchowk Engineering Campus, Institute of Engineering, Tribhuvan University, Lalitpur, Nepal
  • Mahesh Chandra Luintel Department of Mechanical Engineering, Pulchowk Engineering Campus, Institute of Engineering, Tribhuvan University, Lalitpur, Nepal

DOI:

https://doi.org/10.3126/kjem.v3i1.62879

Keywords:

Modal analysis, Meshing of cracks, Stationary nodes, Variation of mode shapes

Abstract

The report outlines ANSYS based modal and structural analysis of a fixed beam of dimension 20mm*20mm*1000mm that was constructed in SOLIDWORKS. Structural steel was selected as the material for analysis. The analysis was done in 3 phases, the first analysis was done without any crack and the other two analysis involved cracked beams with cracks created at different lengths. Suitable boundary and loading conditions were used to find the modes of frequencies. The resulting variation in static deflection, position of mode shapes representing transverse deflection and variation in position of equivalent stress corresponding to varying beam conditions with and without cracks are studied.

Downloads

Download data is not yet available.
Abstract
124
PDF
118

Downloads

Published

2023-06-30

How to Cite

Bhandari, A., Chhetri, A., & Luintel, M. C. (2023). ANSYS based Modal Analysis of a Fixed Beam of Uniform Cross Section with a Concentrated Mass at Mid Span. Kathford Journal of Engineering and Management, 3(1), 87–98. https://doi.org/10.3126/kjem.v3i1.62879

Issue

Vol. 3 No. 1 (2023)

Section

Articles

License

© Kathford International College of Engineering and Management