Electrical characterization of aluminum (Al) thin films measured by using four- point probe method

Authors

  • GP Panta Department of Natural Sciences (Physics) School of Science, Kathmandu University Dhulikhel, Kavre,
  • DP Subedi Department of Natural Sciences (Physics) School of Science, Kathmandu University Dhulikhel, Kavre,

DOI:

https://doi.org/10.3126/kuset.v8i2.7322

Keywords:

Aluminum thin films, electrical resistivity (?), electrical conductivity (?), sheet resistance (Rs), thickness of Al thin films, four- probe set up

Abstract

This paper reports the results of electrical characterization of aluminum thin films. Uniform Al thin films were deposited by physical vapor deposition (PVD) technique on glass substrates. The electrical resistivity of the films as a function of film thickness was studied. These parameters have been measured by four-point probe method. The electrical resistivity was obtained by the measurement of current (in mA) and voltage in (mV) through the probe. The results showed that resistivity of the film decreases linearly with the film thickness in the range of the thickness studied in this work.

Kathmandu University Journal of Science, Engineering and Technology Vol. 8, No. II, December, 2012, 31-36

DOI: http://dx.doi.org/10.3126/kuset.v8i2.7322

Downloads

Download data is not yet available.
Abstract
2388
PDF
1752

Downloads

Published

2013-01-03

How to Cite

Panta, G., & Subedi, D. (2013). Electrical characterization of aluminum (Al) thin films measured by using four- point probe method. Kathmandu University Journal of Science, Engineering and Technology, 8(2), 31–36. https://doi.org/10.3126/kuset.v8i2.7322

Issue

Section

Original Research Articles