Surface Modification of Polycarbonate Using Mesh Electrode at Atmospheric Pressure Discharge at 50 Hz

Authors

  • A.K. Shrestha Kathmandu University, Department of Natural Science, Dhulikhel, Nepal; Damak Multiple Campus, Jhapa, Nepal
  • B.S. Dotel Kathmandu University, Department of Natural Science, Dhulikhel, Nepal
  • S. Dhungana Kathmandu University, Department of Natural Science, Dhulikhel, Nepal
  • R. Shrestha Kathmandu University, Department of Natural Science, Dhulikhel, Nepal
  • H.B. Baniya Kathmandu University, Department of Natural Science, Dhulikhel, Nepal
  • U.M. Joshi Kathmandu University, Department of Natural Science, Dhulikhel, Nepal
  • D.P. Subedi Kathmandu University, Department of Natural Science, Dhulikhel, Nepal

DOI:

https://doi.org/10.3126/kuset.v10i1.63683

Keywords:

Contact angle, Surface energy, Dielectric barrier discharge, Surface polarity

Abstract

This paper reports the result of surface treatment of polycarbonate sample on atmospheric pressure dielectric barrier discharge (APDBD) in argon environment. The discharge was generated in parallel plate DBD system with a fine metal mesh below a barrier using a high voltage power supply (0-20KV) operating at line frequency, 50Hz. The main objective of the study is to investigate improvement of the hydrophilic property of the polymer after the treatment in plasma. The plasma treated samples were characterized by gravimetric method and contact angle measurement with two test liquids and the contact angle data were used for the calculation of surface energy of the samples with its polar and dispersive components. Our result showed that the discharge produces significant improvement in hydrophilicity just after 2 minutes of treatment reducing the contact angle from 88.28° to less than 55°. It was also found that the change in surface energy is mainly due to the increase in polar component of the surface energy.

Downloads

Download data is not yet available.
Abstract
40
PDF
30

Downloads

Published

2014-11-30

How to Cite

Shrestha, A., Dotel, B., Dhungana, S., Shrestha, R., Baniya, H., Joshi, U., & Subedi, D. (2014). Surface Modification of Polycarbonate Using Mesh Electrode at Atmospheric Pressure Discharge at 50 Hz. Kathmandu University Journal of Science, Engineering and Technology, 10(1), 15–19. https://doi.org/10.3126/kuset.v10i1.63683

Issue

Vol. 10 No. 1 (2014)

Section

Original Research Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

This license enables reusers to distribute, remix, adapt, and build upon the material in any medium or format, so long as attribution is given to the creator. The license allows for commercial use. If you remix, adapt, or build upon the material, you must license the modified material under identical terms.