Surface Modification of Polycarbonate by Atmospheric Pressure Cold Argon/Air Plasma Jet

Authors

  • H.B. Baniya Department of Natural Sciences, Kathmandu University, Dhulikhel, Nepal; Department of Physics, Tri-Chandra College, Tribhuvan University, Kathmandu Nepal; National Integrated College (NIC), Dillibazar, Kathmandu, Nepal
  • R. Shrestha Department of Natural Sciences, Kathmandu University, Dhulikhel, Nepal; Department of Physics, Basu H.S.S/College, Kalighat, Byasi Nepal
  • A. Shrestha Department of Natural Sciences, Kathmandu University, Dhulikhel, Nepal
  • S. Shrestha Department of Natural Sciences, Kathmandu University, Dhulikhel, Nepal; National Integrated College (NIC), Dillibazar, Kathmandu, Nepal
  • J.P. Gurung Department of Natural Sciences, Kathmandu University, Dhulikhel, Nepal
  • A.K. Shrestha Department of Natural Sciences, Kathmandu University, Dhulikhel, Nepal
  • D.P. Subedi Department of Natural Sciences, Kathmandu University, Dhulikhel, Nepal

DOI:

https://doi.org/10.3126/kuset.v10i2.63649

Keywords:

Atmospheric plasma, Plasma jet, Surface modification, Contact angle, Surface energy

Abstract

In this paper, atmospheric pressure plasma jet and its application for polymer surface modification is reported. Atmospheric pressure plasma jet sustained in Argon/Air mixture has been used to modify the surface properties of polycarbonate (PC). The surface properties of the untreated and plasma treated PC samples were characterized by contact angle measurement with water and glycerol. The contact angles were used to determine the surface energy and its polar and dispersion components. The effect of treatment time, frequency of the applied voltage, distance of the sample from the nozzle on the wettability of the sample was studied. It was found that the contact angle of water in untreated PC sample is 89° while it decreases to 35° after 5 minutes of treatment time. Moreover, it was found that, the best plasma treatment can be obtained with frequency 27 kHz and a distance of 1 cm between surface of samples (PC) and plasma jet's nozzle. Our result showed that atmospheric pressure non thermal plasma can be effectively used to enhance the surface wettability and surface energy of PC. 

Downloads

Download data is not yet available.
Abstract
39
PDF
31

Downloads

Published

2014-12-31

How to Cite

Baniya, H., Shrestha, R., Shrestha, A., Shrestha, S., Gurung, J., Shrestha, A., & Subedi, D. (2014). Surface Modification of Polycarbonate by Atmospheric Pressure Cold Argon/Air Plasma Jet. Kathmandu University Journal of Science, Engineering and Technology, 10(2), 13–16. https://doi.org/10.3126/kuset.v10i2.63649

Issue

Vol. 10 No. 2 (2014)

Section

Original Research Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

This license enables reusers to distribute, remix, adapt, and build upon the material in any medium or format, so long as attribution is given to the creator. The license allows for commercial use. If you remix, adapt, or build upon the material, you must license the modified material under identical terms.