Prunus domestica dye extraction for fabrication of zinc oxide based dye-sensitized solar cells

Authors

  • Leela Pradhan Joshi Department of Physics, Amrit Campus, Tribhuvan University, Kathmandu

DOI:

https://doi.org/10.3126/bibechana.v13i0.13341

Keywords:

Zinc Oxide, seed layers, spin coating, hydrothermal, solar cells

Abstract

Aluminium doped Zinc Oxide (AZO) seed layers were deposited on Fluorine doped Tin Oxide (FTO) substrates using a spin coating technique. These were then immersed in growth solutions of zinc nitrate, hexamethylenetetramine and distilled water to develop nanoplates of Zinc Oxide (ZnO). The nanostructures of ZnO grown on FTO were studied using x-ray diffraction techniques. Dye-sensitized solar cells (DSSC) were fabricated using two prepared electrodes, one of dye-loaded zinc oxide and another that was platinum coated. The electrolyte used was potassium iodide iodine solution. The performance of the assembled DSCCs was tested by drawing an IV curve. The results showed that the short circuit current and open circuit voltages were about 10 microamperes and 270 millivolts respectively.

BIBECHANA 13 (2016) 23-28

Downloads

Download data is not yet available.
Abstract
816
PDF
734

Downloads

Published

2015-12-03

How to Cite

Joshi, L. P. (2015). Prunus domestica dye extraction for fabrication of zinc oxide based dye-sensitized solar cells. BIBECHANA, 13, 23–28. https://doi.org/10.3126/bibechana.v13i0.13341

Issue

Vol. 13 (2016)

Section

Research Articles

License

This license enables reusers to distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, and only so long as attribution is given to the creator.